CMOS CR2032 Bios UEFI Battery Computer Motherboard System Board Main 3V Lithium

Description

NOTE: There are 2 shipping options
to choose with
different costs
.
1
.
79 Cents
Standard Shipping
with no tracking
. They are shipped in a plain
white envelope to save the extra postage cost below.
2.
USPS
First Class Package Rate. $3.89 postage cost
which provides a tracking
number
As of January 2020 the post office
raised it’s rates to as much as $4.45 retail to get a tracking number which can
only be gotten sending via option 2, First class package.
If you require tracking you MUST choose
“USPS First Class Package”
and switch it from 79 Cents standard shipping to “USPS First Class
Package” rate
DURING CHECKOUT!
1 Piece
PAY 79 CENTS SHIPPING ON ANY QUANTITY
How to replace the CMOS battery
If your computer is losing its time or date settings, or you are receiving a message
CMOS Read Error
,
CMOS checksum error
, or
CMOS Battery Failure
,
first try leaving the computer on for 24-hours. In some cases this can
charge the battery and resolve your issue. This often resolves CMOS
battery related issues when a computer has been left off for several
months. If this does not resolve your issue follow the below steps.
Locate your CMOS battery
Caution:
When inside your computer make sure you’re aware of ESD and all it’s potential dangers.
Open the computer case and find the battery on the computer motherboard,
verify that it will be accessible and that it can be removed. Most
computers today use a coin cell CMOS battery, as shown in the image above.
Tip:
Some CMOS
batteries may be held down by a metal clip or bar. This clip just holds
the battery in place and the battery can still be removed by sliding it
under the clip. Do not bend this clip to get the battery out.
If you are unable to locate your CMOS battery refer to your motherboard or computer documentation or contact your computer manufacturer for additional assistance in locating it.
Obtain battery information
Unfortunately, most manufacturers will not list the
exact type and model of your CMOS battery; therefore, once you have
located the battery, note the number stamped on the battery. The part number for the battery for most computers is CR2032.
Removing the battery
Caution:
When inside your computer make sure you’re aware of ESD and all it’s potential dangers.
If
you’re computer is using a coin cell battery similar to the above
example picture. Removing the battery is relatively simple. use your
fingers to grab on the edge of the battery and pull it up and out of the
container holding it. Some motherboards have a clip holding the battery
down. If your computer has this clip you may need to use one had to
move the clip up and the other hand to pull the battery out.
Unfortunately,
not all CMOS batteries are removable; some manufactures will only allow
a replacement battery to be added. If you’re not using a coin cell
battery and are not able to determine how to remove it refer to your
motherboard or computer documentation or contact your computer manufacturer for additional assistance in removing the battery or how to insert a new replacement battery.
Users
with computers that do not have removable batteries have the only option to
install a new battery will most likely also need to set a jumper when adding the new battery into their computer.
Insert the new
battery
Once you have purchased a new battery, remove the old battery (as instructed above) and replace it with the new battery.
Enter CMOS values
Once the battery is replaced turn on the computer and resetting the CMOS values to defaults. After the values have all been entered make sure to save the settings
before exiting. Many CMOS setups allow you to press a key (such as F10)
to save values and exit all in one action.